help... my car wont go into gear...

[NPb16a2]

alright... i got a civic hatch with a b18, and my car wont go into any gear when the car is on... 1st, 2nd, 3rd, reverse, etc. they go in fine when the engine isnt running. i kno for sure the little rod thingy on the slave clutch cylinder is pushing against the release fork, and they both move. the clutch pedal feels kinda weak. i tried bleeding it, but that didnt help any. should i bleed the clutch more? i've heard the slave cylinder could be bad... or the pressure plate. does anyone else have any suggestions? preferably ones that dont have me droppin the transmission... but i'll take whatever helpful ideas u can give me. thanks.

[NPb16a2]

i was also wonderin if anyone out there knows the lifespan of a clutchmasters clutch... just lookin for an approximation.

[99Lude]

im guessing pressure plate

[MportRacer4Life]

Hey I had a friend with the same problem. The problem with his was the but both of them went bad so u should look into that to. U should also tey bleeding them one more time to see if anything will happen if not well then put it in the shop.

[5w20]

alright... i got a civic hatch with a b18, and my car wont go into any gear when the car is on... 1st, 2nd, 3rd, reverse, etc. they go in fine when the engine isnt running. i kno for sure the little rod thingy on the slave clutch cylinder is pushing against the release fork, and they both move. the clutch pedal feels kinda weak. i tried bleeding it, but that didnt help any. should i bleed the clutch more? i've heard the slave cylinder could be bad... or the pressure plate. does anyone else have any suggestions? preferably ones that dont have me droppin the transmission... but i'll take whatever helpful ideas u can give me. thanks.
.
clutch is shot :rock:

[showstopper]

Make sure the flywheel bolts are still torqued properly....

[NPb16a2]

thanks to all those who responded... i took it down to sylvia werks and replaced the pressure plate, clutch and throttle bearing. its working fine now.

[97teg]

i was gonna say check the slave cylinder, maybe not enough fluid.

D

[Houston hb]

im guessing pressure plate

thinking the same things or just the forks on the plate