PDA

View Full Version : 5 lug swap with 4 lug spindles.


AztecRacer
07-21-2009, 08:49 AM
Found a parts list of what you will need to swap to a 5 lug (5-114mm bolt pattern) set up.
Hope that this will help a few people and happy hunting.

Front Knuckle assembly options:

Option A
97-01 CRV Knuckle's these are the same part number as the JDM DC2 front knuckles they will accomidate a 36mm axle and if you get them complete with rotors and calipers that's all you need, along with JDM ITR 36mm axles, or a outer 36mm cv joint on a stock cv shaft.

Option B
1. 92-95 Civc EX Knuckles
2. 94-01 Integra Knuckles
3.Del Sol Vtec (b16) Knuckles
with this option you will also need either
1.JDM ITR hubs with civic or integra bearings
2.CRV hubs with bearings
3.Prelude hubs with bearings
You will also need 23T calipers found on
ITR, CRV, Prelude
Rotors from:
JDM ITR
CRV
Prelude

Front rotor specs from Brembo:
25464 - Acura 97-01 ITR (Front) Diameter 282.0mm, thickness 23.0mm, min thickness 21.0mm, height 47.1mm
25464 - Honda 97-01 CR-V (Front) Diameter 282.0mm, thickness 23.0mm, min thickness 21.0mm, height 47.1mm
25464 - Honda 97-01 Prelude (Front) Diameter 282.0mm, thickness 23.0mm, min thickness 21.0mm, height 47.1mm

For the rear:

4 lug disc brake rear trailing arm assembly with hub
Type R hubs
Type R Caliper and Brackets from a 98-01 Integra Type R excluding a 1997
Type R brake hose although the OEM 4lug hose will work
Mazda 626, ProtĂgĂ axle nut 93-02
You will discard the original Honda rear washer #3 because the flange on the Mazda nut will be big enough

Last ITR rims or a rim with 5-114mm bolt pattern.


Rear disc options from Brembo:
25550 - Acura 02-06 RSX (Rear) Diameter 259.7mm, thickness 9.0mm, min thickness 8.0mm, height 48.3mm
25550 - Acura 97-01 ITR (Rear) Diameter 259.7mm, thickness 9.0mm, min thickness 8.0mm, height 48.3mm