need dual 4 in exhaust built for sc300

[turboZEE]

i am just wrapping up my GTE swap in my 97 sc300 and want a nice 4 inch exhaust made for it from the downpipe back...no cats no mufflers, just straight pipes

[CarConnection]

i'll look up the prices for those bends and take a rough guess at a price via PM later on today.

thats some seriously big bore pipe however, what turbo are you backing this up with if i might ask?

[CarConnection]

pm sent

[turboZEE]

dont laugh, but im actually on stock twins, but, im somewhere in the mid 400's, thats for sure, so im assumed 4 in would be a little big but still ok to run. also because i plan on goring gt4088r or garret to4z somtime in september.

ok so 1g in parts, and about 5-7 hours labor, how much is ur labor charges?

i wasnt really looking to spend more than a grand or 1200 at most but i guess i really underestimated the price of parts

[CarConnection]

its the bends getting you, full mandrel in 304 at that diameter isn't cheap lol.

but that exhaust is wayyyy overkill for stock twins too, you'd have to then have a custom downpipe made whenever you make the switch, so thats up to you.

our labor rate is $65/hr & $100/fab, your work is fabrication.

if you run a smaller pipe it could get cheaper since bends cost less, if you run single pipe vs. dual it costs less as there are less bends and material used in general, etc...

feel free to swing by and i'll show ya around like i said :thumb:

[turboZEE]

cool, car is at pristine image at the moment getting a fresh coat of paint, i cant say im not excited, so who do i ask for when i get there and how would be the best to get to ur shop (i get lost easily). i am around the 59s/beltway8 SW houston area

[CarConnection]

Just ask for Jeremy when you come in, easiest way from your neck of the woods is BW8 north to 290

north on 290

exit 1960/hwy 6

take a right, go down a few miles till you hit Jones Rd.

right after Jones Rd. there is a whataburger on your right with a road just before it called Windfern Rd.

turn right onto Windfern Rd

go down about 1000 feet and were on the left with a banner over our location.

technical address if you want to mapquest the area is:

PowerFab Automotive
10541 FM 1960 Rd W #703
Houston, TX 77070

[turboZEE]

sounds great, i will swing by as soon as my car gets out of paint and body!i may just go with a 4 inch or 3.5 in (since u suggested a smaller diameter) all the way to the diff and then split it into two 3 inches...maybe even just stick with a full 3 inch exhaust...when i come by, we'll sit down and talk about all my options :) i do appreciate all ur help, see you soon.

-Zeeshaun