LS tranny

[crazy88hatch]

I have a 90 Si Hatch and I just put a LS in it and i need to know how much to cut the shift linkage and the shift stabalizer linkage. Thanks

[93Integra]

I wouldnt go by a specific amout to cut off. Id go by what needs to be taken off on your car. In my experience when cutting was needed I'd mock it up and see how much I needed to cut off, cut it and weld it up and it worked fine.

[crazy88hatch]

Cool man thanks alot cause thats all I need to get my car going

[DA_LsVtAk]

we cut a friend of mines linkage for his rex, just do it right dude i believe it was like 2 inches on each side but dont take my word for it do more research before you start hacking away, look on honda-tech im sure someone has a thread about it

[DRKBLUHATCHver2]

What i did on my rex with a 00 type-r, i just cut the linkage in half, then i went to home depot and got this little bar that went in the middle of it, put the linkage up in the car, then tack welded it once it felt good and shifted smoothly. Took it down and finished the welds.

[crazy88hatch]

Hey thanks I think I am going to try to cut it then bolt it on then weld it where It needs to be. CrAzY 88's

[90-RED-SI]

mock it up next to your stock one

[onekoop]

if the hatch and crx are the same i cut off 2 3/4 off mine