Tru_Dat
04-22-2005, 01:20 PM
Alright heres my situation I have a 96 integra Se with a highflow cat i put on a few months ago. While i was putting it on i noticed that the port for the o2 sensor was on the back and not the front. Like a renob i went ahead a bolted it up and just tied off the sensor. I then bought a o2 simulator from jegs and wired that up but that did not fix the problem. So im drving around burning about a quart of oil a month and getting fuel about every week and a half. I work at O'riellys and was fliping though our aftermarket catalog and saw a skunk2 OBD1 to OBD2 converter for a about 100 bucks. So my main question is this someting that can work. Also if yes do i have to worry about the change messing up my main wiring harness, abs controller, etc... Any feed will be greatly appreciated.