wiring diagrams

[slo4dr]

i need a ecu diagram for a 95 auto rs teg and for a 95 gsr. where can i find these diagrams?

[slo4dr]

i know some one has to know where i can find this harnesses, cause if you didn't know then no one's swaps would run right. can i get some input from someone.

[cypher]

what are you wanting to do? swap a gsr into a ls? so you need the vtec pinouts?

[slo4dr]

yes i need the vetc, knock sensor, and reverse wire pin outs. and i needed to look to see if anything esle is missing.

[cypher]

http://www.ff-squad.com/tech/wiring/wiring.92-95.jpg

[slo4dr]

ok i had that diagram already. i need to know if and what the diffence is with the auto ecu.

[Spo0n_This]

what do you mean by ecu diagram. you cant just convert a auto ecu and even if you could its pointless. are you asking for what pinouts on the harness that plugs into the ecu need to be tapped for vtec?

also if your going from a auto ls to a gsr swap you can only run a 5 speed vtec ecu. rigging up a ls ecu wont work

if you just need a ecu to drive on a ls will work but the thing with auto is that it will hit fuel cut at about 4k in 4th sometimes. not always true but it does happen

[slo4dr]

i have a 95 p72 ecu going into the car. i know how to do the wiring, i just need the pinouts for the two cars so i can make sure all the wires in in the right place. the only thing i need right now is the two diagrams from the 95 p72 and from the 95 ls auto.

[cypher]

i still dont know what the hell your wanting

[DRKBLUHATCHver2]

i have a 95 p72 ecu going into the car. i know how to do the wiring, i just need the pinouts for the two cars so i can make sure all the wires in in the right place. the only thing i need right now is the two diagrams from the 95 p72 and from the 95 ls auto.

Just plug the ecu in, move the pinout for the idle air control. Thats it. Make sure you butt the wires on the P/N safty switch near the shifter.

[mikesrex]

i have a 95 p72 ecu going into the car. i know how to do the wiring, i just need the pinouts for the two cars so i can make sure all the wires in in the right place. the only thing i need right now is the two diagrams from the 95 p72 and from the 95 ls auto.

I'm not exactly sure what you want. If you want to put a GSR swap in an auto teggy, you need to run the VTEC solenoid and pressure switch wires. You also need to run the knock sensor wire. You may want to wire up reverse. All the other wires can be left alone. You'll need to connect the park/neutral wires together so the car can start.

if you insist on needing the pinouts, go to www.helminc.com and buy the book for the 95 integra. You'll find everything you need to find concerning the 95 integra.

[slo4dr]

ok thanks mikesrex. i was wanting to know if the rest of the pin outs were the same besides the vtec wires and the knock sensor.

[AccidentProWn]

http://www.hondahookup.com/manuals/

tons of manuals in PDF form including wiring diagrams

[cypher]

yes they are the same